Looked through shop manual and did not see how to change CO setting. Could someone enlighten us?
waltzoi
Joined
·
96 Posts
I dont think you can in the US or so I hear?
A mate put this on another forum.
If you have a Euro or an MT-09 you can change the CO
Access Co/Diag menu -
Hold down both select/reset buttons. Turn key so dash comes on. Keep holding till diag appears. Press select to show CO.
Hold down both buttons and 1 will appear.
If you press select it will run through 1 then 2 then 3 cylinder.
On each of these hold down both buttons till 0 appears.
Now you can change it up.
Once done on that cylinder press both buttons and repeat for all.
edit: beat me by a minute @Rekt !
A mate put this on another forum.
If you have a Euro or an MT-09 you can change the CO
Access Co/Diag menu -
Hold down both select/reset buttons. Turn key so dash comes on. Keep holding till diag appears. Press select to show CO.
Hold down both buttons and 1 will appear.
If you press select it will run through 1 then 2 then 3 cylinder.
On each of these hold down both buttons till 0 appears.
Now you can change it up.
Once done on that cylinder press both buttons and repeat for all.
edit: beat me by a minute @Rekt !
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
