Yamaha FZ-09 Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
520 Posts
Discussion Starter · #1 ·
Anyone know off hand the pipe size and schedule that slips onto header?

Is the slip on line slide over the outside diameter of header pipe or slide into the inside diameter?
 

·
Registered
Joined
·
154 Posts
I'll measure the size tonight.

"I'm not sure of the diameter, but most slip-on's I've seen slip over the pipe, not inside."
The M4 that I have actually goes OD as well as ID.
 

·
Registered
Joined
·
520 Posts
Discussion Starter · #4 ·
I'll measure the size tonight.

"I'm not sure of the diameter, but most slip-on's I've seen slip over the pipe, not inside."
The M4 that I have actually goes OD as well as ID.
I appreciate it brother.
 

·
Registered
Joined
·
380 Posts
If you order the part for your bike, assuming you use the stock header, the size doesn't matter, lol, :)
 

·
Registered
Joined
·
520 Posts
Discussion Starter · #7 ·
If you order the part for your bike, assuming you use the stock header, the size doesn't matter, lol, :)
Was considering fabricating the exhaust myself, if i was buying it, i would not care about any dimensions as the description of the part would be designated for my bike.
 

·
Registered
Joined
·
154 Posts
2in. OD.
 

·
Registered
Joined
·
520 Posts
Discussion Starter · #9 · (Edited)
Thanks buddy, you happen to remember the pipe schedule?

So pipe size is 1.5" with 2" od, ill need a 2" to slip over, 1.5" pipe has od of 1.9".. looks like x4 45 degree bends after the slip on to header, short length past engine, then climbing up towards mount then a short length back then 45 out side of bike then 45 back... Thats where muffle would slide on.
 
1 - 9 of 9 Posts
Top