Yamaha FZ-09 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
Looking to do a fender eliminator and wanted to know if anyone had steps to removing the factory fender. Thanks in advance.
 

·
Registered
Joined
·
4,424 Posts
There are two sides to the tail section. Two bolts on top of each side and three to four pushpins underneath. Just push in on the center of the round pushpins with a tiny screwdriver and pull them out. After you remove the two bolts, they just about fall off the bike.
 
1 - 2 of 2 Posts
Top