Yamaha FZ-09 Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
unsure, attempting to put Arrow bar end mirrors integrated with rhinomoto bar end sliders, just don't know where to start?
 

·
Registered
Joined
·
3,842 Posts
super easy - get a metric allan key - i'm pretty sure it's like a 10mm. Take the stock ones off - i believe the rhino bar ends use an 8mm but not 100% sure.

Make sure you put blue loctite on the threads before installing the rhinos - if this takes you more than 5 minutes - you've done something wrong :)
 

·
Registered
Joined
·
657 Posts
They need a little muscle to break loose.
 
  • Like
Reactions: dave.martin

·
Registered
Joined
·
835 Posts
super easy - get a metric allan key - i'm pretty sure it's like a 10mm. Take the stock ones off - i believe the rhino bar ends use an 8mm but not 100% sure.

Make sure you put blue loctite on the threads before installing the rhinos - if this takes you more than 5 minutes - you've done something wrong :)
I think it was a 10mm Allen key. Definitely a fat one!
 
  • Like
Reactions: dave.martin

·
Registered
Joined
·
300 Posts
Could have sworn it was an 8mm allen key. Take the old ones out. Take the caps off the rhino moto bar ends. Put a dab of blue thread locker on the rhino moto bar ends. Install and tighten.
 
1 - 7 of 7 Posts
Top