Yamaha FZ-09 Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
Hi everyone I just got an alarm system for my bike, sr i600 from Scorpio to be exact for the ones that they are familiar with it. And my question is: on the installation diagram has this picture(

Which I assume that the two grey wires have to be connected one with the right rear and one with the left rear turn signals and orange to tail light, please correct me if i am wrong. Which means that when alarm is armed or triggered those lights will start blinking if I am correct. My question is that if there is a way that I can connect rear and front blinkers so they all flash when alarm is triggered instead just the rear ones only.
Thank you for your input everyone!!
 

·
Registered
Joined
·
1,374 Posts
Wire, splicer, bullet terminals and posi-taps, are you comfortable working with those?
 

·
Registered
Joined
·
1,374 Posts
I would say run some lead wire from those gray cables to all for turn signals.

Or, run a lead to the hazard light system. that way you can tap into all four blinkers in one spot.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top