Yamaha FZ-09 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
Hi,

I recently acquired an xsr900 2016. The battery was shot and I charged it the vehicle with a trickle charger. I reinstalled the battery and upon doing so the hazard lights initiated. It stays on even when bike is running. Most obvious is that i accidently bumped the hazard switch. This is not the case.
Any advise. Could it be a fuse? Or can I reset on board computer? I also have alarm installed

Thanks
 

·
Registered
Joined
·
1,516 Posts
Disconnect or unplug the alarm and see if the hazard lights still stay lit, the ECU has nothing to do with the hazards. It’s possible the alarm is cross wired...or just a bad alarm
 
1 - 2 of 2 Posts
Top