Yamaha FZ-09 Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Got bored and decided to try my hand at making a relocation bracket for the gauge.
Basically made a template using cardboard, then transferring it over to the Alu plate. Took a bit of work since the Jigsaw blades kept wearing out, eventually finished off with a hacksaw and angle grinder.
Dremeled a bit, then smoothed out with sandpaper. Items used: 0.125 mm Aluminum Plate, Jigsaw, Hacksaw, Dremel, Porter cable angle grinder, drill, sandpaper, Spray paint.
Will update on the install.
.
157860
157866


157864
157865
 

·
Registered
Joined
·
168 Posts
nice work. I didnt like the guage off center either. I order the relocation bracket too....also went to blacked out display and love it....all
 
1 - 6 of 6 Posts
Top