Yamaha FZ-09 Forum banner
1 - 4 of 4 Posts

·
Registered
2016 Yamaha FZ-09
Joined
·
2 Posts
Discussion Starter · #1 ·
Hey guys, first post in the forum. I am a mechanical engineer and bought an FZ-09 about a month ago. I designed a custom bracket I cut using a CNC plasma table. If anyone has been wanting to make a newer model wind screen fit, let me know and I could send the .DXF file, or a dimensioned drawing, so you can custom fab one. Note: I did use 2, 3/8" rubber spacers between the plate and bike, as well as plate and windscreen, so it lifted above the speedo. You may also need to replace original hardware with longer bolts. It sits lower than typical windscreens and gives a nice low profile look.

166105

166106
166107
 

·
Registered
2016 XSR900 60th Anniv. Edition
Joined
·
2,668 Posts
I am a mechanical engineer and bought an FZ-09 about a month ago. I designed a custom bracket I cut using a CNC plasma table.
You could be a handy guy to know. Stick around…. 😁
 

·
Registered
2016 Yamaha FZ-09
Joined
·
2 Posts
Discussion Starter · #4 ·
Noice - but first buy your CNC plasma table... ;)
Percs of the job. :) you could always fab something similar with other tools. Won't look as nice but will get the job done as long as bolt holes line up
 
1 - 4 of 4 Posts
Top