Yamaha FZ-09 Forum banner

electrical

  1. 2015 FZ09 Display Issues

    FZ-09 General Discussion
    2015 FZ09 Everything was perfect when I rode it last. Wasn't driven for 3-4 days (rainy). When I turn the key on, my display works fine - but after a few seconds (3-10 sec): it goes blank (no speedometer, gear indicator. gas gauge, etc.) but the neutral, flasher and high beam indicators along...
  2. ECU pinout diagrsm

    FZ-09 General Discussion
    I am about to install a sequential shift light on my '15 and I need a digital RPM signal either at the dash or the ecu. Anyone know which on it is or have a pinout diagram for these. I have spent 2 days but my googlefoo apparently sucks.
  3. ABS on 2019 MT 09

    FZ-09 General Discussion
    Hi, does anyone know if the ABS light being on permanently is intentional? Manual doesn't say anything about this and this thread says its supposed to turn off after 10km. I have 200 miles on my bike and when I started it today for no reason the ABS light did not turn on at all, whereas it...
  4. Electrical Question

    FZ-09 General Discussion
    I've been having an issue with my bike for a good year and a half now and I'm having a tough time trying to figure out the cause of it. The issue is that when I'm riding and try to tuck my knees in to the tank I get a buzzing sensation in my left leg when it is touching between the gap of my...
  5. Total Wattage Draw

    XSR900 General Discussion
    Hi. I'm planning to put some load on my electrical system with heated gear and I'm trying to figure out the total wattage draw of the bike so I can determine how much is left over for the accessories. The service manual says that it produces 415 W @ 5000 rpm, but doesn't say how much the bike...
  6. LED Problems

    Yamaha FZ-09 Common Problems/Issues
    I have decided to do headlight, euro headlights, front and rear turn signals, and rear brake light all in LED. After installing them my buddy and I went to turn it in and test it and only the headlight worked. My first obvious troubleshoot was to check fuses and sure enough I'm blowing two fuses...
Top