Yamaha FZ-09 Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 4 Results
  1. FZ/MT09 General Discussion
    Hi All, I am trying to install a Brembo M4 caliper + 2005 R1 rotor (320 mm). I have ordered Brembo's spacers (220.A061.75 - 12 mm) but they are too short. I can't tie calipers fully (better to say torque screws), if I do so I lock the wheel (it locks to the edge/top of rotor, not on the sides...
  2. FZ/MT09 Gear & Accessories
    The image below indicates that in order to adjust the breaking pressure from 19x20 to 19x18 is by simply rotating the adjuster screw by 180 degrees. Now lets say if I messed around with the adjuster screw but instead of going back and forth 180 degrees, I accidentally rotated it 360 degrees...
  3. FZ/MT09 Builds
    I have been eyeballing the FZ09 for a little over a year now. I have always been a fan of the Three cylinder engine package and how it delivers power on the low end. I have ridden a four cylinder a twin cylinder and even a single cylinder street bike over the past few years and have always had a...
1-3 of 4 Results
Top